Calculator  Home  Frequently Asked Questions  Search This Site  Guestbook  Feedback   

SAM-Consult
Machteld van 
Meterenlaan 30
2628 LR  Delft
The Netherlands
Tel: +31-15-2616939
Fax: +31-15-2569303
Email: info@samconsult.biz
Map of Delft
 
Home
Up
Introduction
Ductile Materials
Brittle Materials
Failure Prevention

 

Solid Mechanics: Failure Criteria
Techniques for Failure Prevention and Diagnosis

 

There exist a set of basic techniques for preventing failure in the design stage, and for diagnosing failure in manufacturing and later stages.
In the Design Stage
It is quite commonplace today for design engineers to verify design stresses with finite element (FEA) packages. This is fine and good when FEA is applied appropriately. However, the popularity of finite element analysis can condition engineers to look just for red spots in simulation output, without really understanding the essence or funda at play.

By following basic rules of thumb, such danger points can often be anticipated and avoided without total reliance on computer simulation.

Loading Points Maximum stresses are often located at loading points, supports, joints, or maximum deflection points.
Stress
Concentrations		 Stress concentrations are usually located near corners, holes, crack tips, boundaries, between layers, and where cross-section areas change rapidly.

Sound design avoids rapid changes in material or geometrical properties. For example, when a large hole is removed from a structure, a reinforcement composed of generally no less than the material removed should be added around the opening.
Safety Factors The addition of safety factors to designs allow engineers to reduce sensitivity to manufacturing defects and to compensate for stress prediction limitations.
In Post-Manufacturing Stages
Despite the best efforts of design and manufacturing engineers, unanticipated failure may occur in parts after design and manufacturing. In order for projects to succeed, these failures must be diagnosed and resolved quickly and effectively. Often, the failure is caused by a singular factor, rather than an involved collection of factors.

Such failures may be caught early in initial quality assurance testing, or later after the part is delivered to the customer.

Induced
Stress
Concentrations		 Stress concentrations may be induced by inadequate manufacturing processes.

For example, initial surface imperfections can result from sloppy machining processes. Manufacturing defects such as size mismatches and improper fastener application can lead to residual stresses and even cracks, both strong stress concentrations.
Damage
and Exposure		 Damages during service life can lead a part to failure. Damages such as cracks, debonding, and delamination can result from unanticipated resonant vibrations and impacts that exceed the design loads. Reduction in strength can result from exposure to UV lights and chemical corrosion.
Fatigue
and Creep		 Fatigue or creep can lead a part to failure. For example, unanticipated fatigue can result from repeated mechanical or thermal loading.

 

 

Copyright © efunda.com
 
 

Back Home Up

Send mail to webmaster@samconsult.biz with questions or comments about this web site.
Copyright © 2002-2006 SAM-Consult
Last modified: June 01, 2006